首頁 電源管理 DC/DC 電源模組 電源模組 (整合式電感器)
首頁
電源管理
DC/DC 電源模組
電源模組 (整合式電感器)
最新

TPSM828303

現行

採用 QFN 封裝，且具整合式電感器的 2.25-V 至 5.5-V、3-A 低雜訊降壓模組

立即訂購
產品規格表

TPSM828303

現行
產品規格表 立即訂購

產品詳細資料

Rating Catalog Operating temperature range (°C) -40 to 125 Topology Synchronous Buck Type Module Iout (max) (A) 3 Vin (min) (V) 2.25 Vin (max) (V) 5.5 Vout (min) (V) 0.5 Vout (max) (V) 4.5 Switching frequency (min) (kHz) 2000 Switching frequency (max) (kHz) 2000 Features 1% accuracy, 1.2-V compatible control inputs, EMI Tested, EMI filtering, Enable, Forced PWM, Light Load Efficiency, Output discharge, Overcurrent protection, Power good, Synchronous Rectification Control mode DCS-Control Duty cycle (max) (%) 100
Rating Catalog Operating temperature range (°C) -40 to 125 Topology Synchronous Buck Type Module Iout (max) (A) 3 Vin (min) (V) 2.25 Vin (max) (V) 5.5 Vout (min) (V) 0.5 Vout (max) (V) 4.5 Switching frequency (min) (kHz) 2000 Switching frequency (max) (kHz) 2000 Features 1% accuracy, 1.2-V compatible control inputs, EMI Tested, EMI filtering, Enable, Forced PWM, Light Load Efficiency, Output discharge, Overcurrent protection, Power good, Synchronous Rectification Control mode DCS-Control Duty cycle (max) (%) 100
QFN-FCMOD (RDS) 9 9 mm² 3 x 3 QFN-FCMOD (VCB) 10 6.5 mm² 2.6 x 2.5
  • Optimized EMI performance
  • Facilitates CISPR 11/32 compliance
    • Integrated on-chip noise-filtering capacitors
    • Measurements according to CISPR available
  • 0.5V to 4.5V adjustable output voltage
  • 1% FB voltage accuracy (–40°C to 125°C TJ)
  • 55mΩ dropout resistance
  • 2.25V to 5.5V input voltage range
  • 2.0MHz switching frequency
  • 7µA operating quiescent current
  • DCS-Control topology
  • Excellent transient response
  • MODE pin selects between forced PWM and power save mode
  • Supports 1.2V GPIO
  • 100% duty cycle for lowest dropout
  • Active output discharge
  • Power-good output
  • Thermal shutdown protection
  • Hiccup or latch-off OCP/OVP
  • PSpice and SIMPLIS models available
  • Two package options with 0.5mm pitch
    • Standard QFN
    • Shielded MagPack
  • Create a custom design using the TPSM828303 with the WEBENCH® Power Designer
  • Optimized EMI performance
  • Facilitates CISPR 11/32 compliance
    • Integrated on-chip noise-filtering capacitors
    • Measurements according to CISPR available
  • 0.5V to 4.5V adjustable output voltage
  • 1% FB voltage accuracy (–40°C to 125°C TJ)
  • 55mΩ dropout resistance
  • 2.25V to 5.5V input voltage range
  • 2.0MHz switching frequency
  • 7µA operating quiescent current
  • DCS-Control topology
  • Excellent transient response
  • MODE pin selects between forced PWM and power save mode
  • Supports 1.2V GPIO
  • 100% duty cycle for lowest dropout
  • Active output discharge
  • Power-good output
  • Thermal shutdown protection
  • Hiccup or latch-off OCP/OVP
  • PSpice and SIMPLIS models available
  • Two package options with 0.5mm pitch
    • Standard QFN
    • Shielded MagPack
  • Create a custom design using the TPSM828303 with the WEBENCH® Power Designer

The TPSM82830x are an easy-to-use, synchronous, step-down, DC/DC module family with integrated inductor and EMI reduction technologies. Based on the DCS-Control topology, the devices have a fast transient response yet with small output capacitance. The output voltage can be set down to 0.5V with high feedback voltage accuracy of 1% over the full operating junction temperature range. A mode pin selects between power saving and forced-PWM mode. The power save mode prolongs battery life at low output currents and the forced PWM mode maintains continuous conduction in the inductor to reduce ripple at constant switching frequency. An internal soft-start circuit ramps the voltage up tightly controlled and a power-good signal indicates correct output voltage. The devices support 100% mode. HICCUP short-circuit protection combined with thermal shutdown protect device and application. The family is available in a 3.0mm × 3.0mm × 1.95mm QFN package and 2.5mm × 2.6mm × 1.95mm MagPack package.

The TPSM82830x are an easy-to-use, synchronous, step-down, DC/DC module family with integrated inductor and EMI reduction technologies. Based on the DCS-Control topology, the devices have a fast transient response yet with small output capacitance. The output voltage can be set down to 0.5V with high feedback voltage accuracy of 1% over the full operating junction temperature range. A mode pin selects between power saving and forced-PWM mode. The power save mode prolongs battery life at low output currents and the forced PWM mode maintains continuous conduction in the inductor to reduce ripple at constant switching frequency. An internal soft-start circuit ramps the voltage up tightly controlled and a power-good signal indicates correct output voltage. The devices support 100% mode. HICCUP short-circuit protection combined with thermal shutdown protect device and application. The family is available in a 3.0mm × 3.0mm × 1.95mm QFN package and 2.5mm × 2.6mm × 1.95mm MagPack package.
filter 尋找其它 電源模組 (整合式電感器)
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
引腳對引腳的功能與所比較的產品相同
最新 TPSM828302 現行 具有整合式電感器的 2.25-V 至 5.5-V、2-A 高效率降壓電源模組 Pin-to-pin compatible variant with 2-A output current
功能相同，但引腳輸出與所比較的產品不同
TPSM82823 現行 具整合式電感器、採用 2.0-mm × 2.5-mm × 1.1-mm uSiP 封裝的 5.5-V 輸入、3-A 降壓模組 Module with smaller solution size
功能相似於所比較的產品
最新 TPS628303 現行 採用小型 QFN 及 SOT583 封裝且具有 1% 準確度的 2.25-V 至 5.5-V、3-A 降壓轉換器 Buck converter with same functionality and external inductor
TPSM82813 現行 具備選用頻率同步化、可調整緩啟動和追蹤功能的 6V 3A 降壓模組 Module with fixed-frequency and external synchronization capability

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 4
類型 標題 日期
* Data sheet TPSM82830x, Low EMI, 2.25V to 5.5V input, 1A, 2A and 3A Step-Down Power Module With Integrated Inductor in QFN and MagPack Package datasheet (Rev. B) PDF | HTML 2024年 6月 27日
EVM User's guide TPSM828303PEVM-058 Evaluation Module User's Guide PDF | HTML 2024年 6月 13日
EVM User's guide TPSM82830xAEVM-245 Evaluation Module User's Guide PDF | HTML 2023年 7月 26日
Certificate TPSM828303AEVM-245 EU Declaration of Conformity (DoC) 2023年 7月 25日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

TPSM828303AEVM-245 — TPSM828303A 評估模組適用於具整合式電感器的 3-A 降壓式降壓轉換器模組

TPSM828303AEVM-245 評估模組 (EVM) 會加速 TPSM828303 的評估，而這一款採用了 3.0 x 3.0 x 2.0 mm QFN 封裝，具備整合式電感器的 3.A 降壓式電源模組。EVM 將 2.25 V 至 5.5 V 輸入電壓轉換為 1.8 V 的穩壓輸出電壓。其根據 DCS 控制拓撲結構，提供含小型輸出電容的快速瞬態回應。內部參考允許在結溫 40°C 至 125°C 範圍內將輸出電壓調節至 0.5 V，具高回饋電壓準確度 1%。

使用指南: PDF | HTML
TI.com 無法提供
開發板

TPSM828303PEVM-058 — TPSM828303P 評估模組

TPSM828303PEVM-058 可幫助對 TPSM828303PVCB 的評估，TPSM828303PVCB 採用 2.5mm × 2.6mm × 2.0mm MagPack™ 封裝，為一款具有整合式電感器的 3A 同步降壓式 DC/DC 電源模組。TPSM828303P 評估模組 (EVM) 簡單且易於使用。此 EVM 使用 2.25V 至 5.5V 輸入電壓將輸出電壓調節至 1.8V。不過，EVM 的輸出電壓可在 0.5V 至 4.5V 間進行調整，且在完整輸入電壓和結溫範圍中的準確度為 1%。
使用指南: PDF | HTML
TI.com 無法提供
封裝 針腳 CAD 符號、佔位空間與 3D 模型
QFN-FCMOD (RDS) 9 Ultra Librarian
QFN-FCMOD (VCB) 10 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片