首頁 電源管理 AC/DC 和 DC/DC 控制器 (外部 FET)
首頁
電源管理
AC/DC 和 DC/DC 控制器 (外部 FET)

LM25143

現行

具超低 IQ 的 3.5-V 至 42-V、雙輸出、堆疊式同步降壓 DC/DC 控制器

立即訂購
產品規格表

LM25143

現行
產品規格表 立即訂購

產品詳細資料

Vin (min) (V) 3.5 Vin (max) (V) 47 Iout (max) (A) 100 Operating temperature range (°C) -40 to 150 Control mode current mode Topology Buck Controller Rating Catalog Vout (min) (V) 0.6 Vout (max) (V) 36 Features Adjustable current limit, Enable, Frequency synchronization, Light Load Efficiency, Multiple Outputs, Phase Interleaving, Power good, Pre-Bias Start-Up, Spread Spectrum, Synchronous Rectification, UVLO adjustable Iq (typ) (µA) 16.5 Duty cycle (max) (%) 99 Number of phases 2 TI functional safety category Functional Safety-Capable
Vin (min) (V) 3.5 Vin (max) (V) 47 Iout (max) (A) 100 Operating temperature range (°C) -40 to 150 Control mode current mode Topology Buck Controller Rating Catalog Vout (min) (V) 0.6 Vout (max) (V) 36 Features Adjustable current limit, Enable, Frequency synchronization, Light Load Efficiency, Multiple Outputs, Phase Interleaving, Power good, Pre-Bias Start-Up, Spread Spectrum, Synchronous Rectification, UVLO adjustable Iq (typ) (µA) 16.5 Duty cycle (max) (%) 99 Number of phases 2 TI functional safety category Functional Safety-Capable
VQFN (RHA) 40 36 mm² 6 x 6
  • Functional Safety-Capable
  • Versatile synchronous buck DC/DC controller
    • Wide input voltage range of 3.5 V to 42 V
    • 1% accurate, fixed 3.3-V, 5-V, or adjustable outputs from 0.6 V to 36 V
    • 150°C maximum junction temperature
    • 4-µA typical shutdown mode current
    • 15-µA typical no-load standby current
  • Two interleaved synchronous buck channels
    • Dual channel or single-output multiphase
    • 65-ns tON(min) for high VIN/VOUT ratio
    • 60-ns tOFF(min) for low dropout
  • Inherent protection features for robust design
    • Shunt or inductor DCR current sensing
    • Hiccup mode overcurrent protection
    • Independent ENABLE and PGOOD functions
    • Adjustable output voltage soft start
    • VCC, VDDA, and gate-drive UVLO protection
    • Thermal shutdown protection with hysteresis
  • Optimized for CISPR 11 and CISPR 32 class B conducted and radiatedEMI requirements
    • Slew-rate controlled adaptive gate drivers
    • Spread spectrum reduces peak emissions
  • 100-kHz to 2.2-MHz switching frequency
    • SYNC in and SYNC out capability
    • Selectable diode emulation or FPWM modes
  • 6-mm × 6-mm VQFN-40 package
  • Create a custom design using the LM25143 with WEBENCH Power Designer
  • Functional Safety-Capable
  • Versatile synchronous buck DC/DC controller
    • Wide input voltage range of 3.5 V to 42 V
    • 1% accurate, fixed 3.3-V, 5-V, or adjustable outputs from 0.6 V to 36 V
    • 150°C maximum junction temperature
    • 4-µA typical shutdown mode current
    • 15-µA typical no-load standby current
  • Two interleaved synchronous buck channels
    • Dual channel or single-output multiphase
    • 65-ns tON(min) for high VIN/VOUT ratio
    • 60-ns tOFF(min) for low dropout
  • Inherent protection features for robust design
    • Shunt or inductor DCR current sensing
    • Hiccup mode overcurrent protection
    • Independent ENABLE and PGOOD functions
    • Adjustable output voltage soft start
    • VCC, VDDA, and gate-drive UVLO protection
    • Thermal shutdown protection with hysteresis
  • Optimized for CISPR 11 and CISPR 32 class B conducted and radiatedEMI requirements
    • Slew-rate controlled adaptive gate drivers
    • Spread spectrum reduces peak emissions
  • 100-kHz to 2.2-MHz switching frequency
    • SYNC in and SYNC out capability
    • Selectable diode emulation or FPWM modes
  • 6-mm × 6-mm VQFN-40 package
  • Create a custom design using the LM25143 with WEBENCH Power Designer

The LM25143 is a 42-V DC/DC synchronous buck controller for high-current single or dual outputs. Deriving from a family of wide-VIN range controllers, the device uses an interleaved, stackable, peak current-mode control architecture for easy loop compensation, fast transient response, excellent load and line regulation, and accurate current sharing with paralleled phases for higher output current. A high-side switch minimum on time of 65 ns provides large step-down ratios, enabling the direct conversion from 12-V or 24-V inputs to low-voltage rails for reduced system complexity and cost. The LM25143 continues to operate during input voltage dips as low as 3.5 V, at nearly 100% duty cycle if needed.

The 15-µA no-load quiescent current with the output voltage in regulation extends operating run-time in battery-powered systems. Power the LM25143 from the output of the switching regulator or another available source for even lower input quiescent current and power loss.

The LM25143 is a 42-V DC/DC synchronous buck controller for high-current single or dual outputs. Deriving from a family of wide-VIN range controllers, the device uses an interleaved, stackable, peak current-mode control architecture for easy loop compensation, fast transient response, excellent load and line regulation, and accurate current sharing with paralleled phases for higher output current. A high-side switch minimum on time of 65 ns provides large step-down ratios, enabling the direct conversion from 12-V or 24-V inputs to low-voltage rails for reduced system complexity and cost. The LM25143 continues to operate during input voltage dips as low as 3.5 V, at nearly 100% duty cycle if needed.

The 15-µA no-load quiescent current with the output voltage in regulation extends operating run-time in battery-powered systems. Power the LM25143 from the output of the switching regulator or another available source for even lower input quiescent current and power loss.
filter 尋找其它 AC/DC 和 DC/DC 控制器 (外部 FET)
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
功能相同，但引腳輸出與所比較的裝置不同
LM25148 現行 具有超低 IQ 的 42-V 同步降壓 DC/DC 控制器 Single output stackable to two phases.
LM25149 現行 具超低 IQ 和整合式主動 EMI 濾波器的 42-V 同步降壓 DC/DC 控制器 Single output stackable to two phases with active EMI filter.

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 5
類型 標題 日期
* Data sheet LM25143 3.5-V to 42-V Dual Synchronous Buck DC/DC Controller With Ultra-Low IQ datasheet PDF | HTML 2022年 3月 18日
Application note How to Implement a Simple Constant Current Regulation Scheme to a PCM Based Buck PDF | HTML 2023年 8月 16日
Functional safety information LM25143 Functional Safety, FIT Rate, Failure Mode Distribution and Pin FMA PDF | HTML 2022年 2月 17日
E-book An Engineer’s Guide to Low EMI in DC/DC Regulators 2021年 4月 21日
Application note LM5143-Q1 4-phase Buck Regulator Design (Rev. A) PDF | HTML 2020年 4月 28日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

LM5143-Q1EVM-2100 — 雙通道汽車同步降壓控制器評估模組

The LM5143-Q1-EVM2100 high density evaluation module (EVM) is designed to showcase the performance of the LM5143-Q1 high performance, dual-channel, automotive synchronous buck DC/DC buck controller. It operates over a wide input voltage range of 3.5 V to 36 V to deliver fixed 5-V and 3.3-V outputs (...)
使用指南: PDF
TI.com 無法提供
計算工具

LM5143DESIGN-CALC — LM5143-Q1 Controller Quickstart Design Tool

This stand-alone tool facilitates and assists with the design of a DC/DC buck regulator based on the LM5143-Q1 synchronous buck DC/DC controller with low IQ. The user can expeditiously arrive at an optimized design to meet the application requirements.

支援產品和硬體

支援產品和硬體

產品
AC/DC 和 DC/DC 控制器 (外部 FET)
LM25143 — 具超低 IQ 的 3.5-V 至 42-V、雙輸出、堆疊式同步降壓 DC/DC 控制器 LM25143-Q1 — 車用 3.5-V 至 42-V、低 IQ、雙輸出、堆疊式同步降壓 DC-DC 控制器 LM5143 — 具超低 IQ 的 3.5-V 至 65-V、雙輸出、堆疊式同步降壓 DC/DC 控制器 LM5143-Q1 — 3.5V 至 65V 低 IQ、雙路雙相同步降壓 DC-DC 控制器 LM5143A-Q1 — 車用 3.5-V 至 65-V、低 IQ、雙輸出、堆疊式同步降壓 DC-DC 控制器
硬體開發
開發板
LM5143-Q1EVM-2100 — 雙通道汽車同步降壓控制器評估模組
軟體
計算工具
LM5143DESIGN-CALC — LM5143-Q1、LM5143A-Q1、LM5143、LM25143-Q1 及 LM25143 控制器快速入門設計工具
下載
參考設計

PMP31202 — 四相降壓轉換器 700-W 參考設計

此參考設計為使用 LM5143A-Q1 產品的 700-W 降壓轉換器。由於具有低失效時間、超強驅動器與可個別調整上升和下降邊緣的能力，因此效率可達 98%。由於損耗降低，因此基板面積為 150 mm × 125 mm，高度則為小巧的 12 mm 或 15 mm (視所選電感器而定)。透過使用強制冷卻或安裝在機箱上的散熱器，因此具有足夠的空餘空間來提高輸出功率。使用額外的冷卻選項，輸出電流可增加至 60-A 連續與以上。交錯式運作可在輸入電容器上產生低均方根 (RMS) 應力，並減少輸入與輸出的漣波。提供通用兩級 EMI 輸入濾波器。
Test report: PDF
封裝 針腳 CAD 符號、佔位空間與 3D 模型
VQFN (RHA) 40 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片