The TPS54618 device is a full-featured 6-V, 6-A, synchronous step-down current-mode converter with two integrated MOSFETs.
The TPS54618 enables small designs by integrating the MOSFETs, implementing current-mode control to reduce external component count, reducing inductor size by enabling up to 2-MHz switching frequency, and minimizing the IC footprint with a small, 3-mm × 3-mm, thermally-enhanced WQFN package.
The TPS54618 provides accurate regulation for a variety of loads with an accurate ±1% voltage reference (VREF) over temperature.
Efficiency is maximized through the integrated
12-mΩ MOSFETs and 515-µA typical supply current. Using the enable pin, shutdown supply current is reduced to 5.5-µA by entering a shutdown mode.
Undervoltage lockout is internally set at 2.6 V, but can be increased by programming the threshold with a resistor network on the enable pin. The output-voltage start-up ramp is controlled by the slow-start pin. An open-drain power-good signal indicates the output is within 93% to 107% of its nominal voltage.
Frequency foldback and thermal shutdown protect the device during an overcurrent condition.
For more SWIFT™ documentation, see the TI website at www.ti.com/swift.
| 類型 | 標題 | 日期 | ||
|---|---|---|---|---|
| * | Data sheet | TPS54618 2.95-V to 6-V, 6-A, Synchronous Step-Down SWIFT Converter datasheet (Rev. F) | PDF | HTML | 2019年 5月 24日 |
| Application note | Semiconductor and IC Package Thermal Metrics (Rev. D) | PDF | HTML | 2024年 3月 25日 | |
| Application note | Step-Dwn (Buck) Convrtr Pwer Solutions for Programmable Logic Controller Systems (Rev. A) | PDF | HTML | 2021年 7月 26日 | |
| Selection guide | Buck Converter Quick Reference Guide (Rev. B) | 2021年 4月 8日 | ||
| Application note | Calculating Efficiency (Rev. A) | 2020年 3月 6日 | ||
| Application note | Solve Point-of-Load Power Design Challenges: Single Board Computer Applications | 2018年 8月 24日 | ||
| Selection guide | Power Management Guide 2018 (Rev. R) | 2018年 6月 25日 | ||
| User guide | TPS54618EVM-606, 6-A SWIFT Regulator Evaluation Module (Rev. A) | 2012年 3月 5日 | ||
| Application note | Understanding Thermal Dissipation and Design of a Heatsink | 2011年 5月 4日 | ||
| Application note | Designing Type III Compensation for Current Mode Step-Down Converters (Rev. A) | 2010年 9月 15日 |
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
| 封裝 | 針腳 | CAD 符號、佔位空間與 3D 模型 |
|---|---|---|
| WQFN (RTE) | 16 | Ultra Librarian |