The TPS6123x is a high current, high efficiency synchronous boost converter with constant output current feature for single cell Li-Ion and Li-polymer battery powered products, in a wide range of power bank, tablet, and other portable devices. The IC integrates 14-mΩ/14-mΩ power switches and is capable of delivering up to a 3.5-A output current for 3.3-V to 5-V conversion with up to 97% high efficiency. The device supports a programmable constant output current to control power delivery, so to save power path components and lower total system thermal dissipation effectively.
The device only consumes a 10-µA quiescent current under a light load condition, and can report load status to the system, which make it very suitable for Always-On applications. With the TPS6123x, a simple and flexible system design can be achieved, eliminating external power path components, saving PCB space, and reducing BOM cost.
In shutdown, the output is completely disconnected from the input, and current consumption is reduced to less than 1 µA. Other features like soft start control, reverse current blocking, over voltage protection, and thermal shutdown protection are built-in for system safety.
The devices are available in a 2.5-mm × 2.5-mm VQFN package.
| Typ | Titel | Datum | ||
|---|---|---|---|---|
| * | Data sheet | TPS6123x 8-A Valley Current Synchronous Boost Converters with Constant Current Output Feature datasheet (Rev. A) | PDF | HTML | 18 Apr 2016 |
| Application note | Basic Calculation of a Boost Converter's Power Stage (Rev. D) | PDF | HTML | 28 Okt 2022 | |
| Application note | Performing Accurate PFM Mode Efficiency Measurements (Rev. A) | 11 Dez 2018 | ||
| Application note | Automated Frequency Response Analyzer | 09 Okt 2013 | ||
| Analog Design Journal | Design considerations for a resistive feedback divider in a DC/DC converter | 26 Apr 2012 | ||
| Application note | Understanding the Absolute Maximum Ratings of the SW Node (Rev. A) | 13 Jan 2012 | ||
| Application note | Choosing an Appropriate Pull-up/Pull-down Resistor for Open Drain Outputs | 19 Sep 2011 | ||
| Analog Design Journal | IQ: What it is, what it isn’t, and how to use it | 17 Jun 2011 | ||
| Application note | Minimizing Ringing at the Switch Node of a Boost Converter | 15 Sep 2006 |
Weitere Bedingungen oder erforderliche Ressourcen enthält gegebenenfalls die Detailseite, die Sie durch Klicken auf einen der unten stehenden Titel erreichen.
This EVM is used to evaluate the synchronous boost converter TPS61236, which features 3A output current at 5V VOUT, < 3µA ultra-low current and programmable output current limit. The EVM can also be used to evaluate the fixed 5.1V version TPS61235. In this case the feedback resistors are (...)
| Gehäuse | Pins | CAD-Symbole, Footprints und 3D-Modelle |
|---|---|---|
| VQFN-HR (RWL) | 9 | Ultra Librarian |
Inhalte werden ohne Gewähr von TI und der Community bereitgestellt. Sie stellen keine Spezifikationen von TI dar. Siehe Nutzungsbedingungen.
Bei Fragen zu den Themen Qualität, Gehäuse oder Bestellung von TI-Produkten siehe TI-Support.