The TPS6120x devices provide a power supply solution for products powered by either a single-cell, two-cell, or three-cell alkaline, NiCd or NiMH, or one-cell Li-Ion or Li-polymer battery. It is also used in fuel cell or solar cell powered devices where the capability of handling low input voltages is essential. Possible output currents depend on the input to output voltage ratio. The devices provide output currents of up to 600 mA at a 5-V output, while using a single-cell Li-Ion or Li-Polymer battery and discharges it down to 2.6 V. The boost converter is based on a fixed frequency, pulse-width-modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters the Power Save mode to maintain a high efficiency over a wide load current range. The Power Save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The average input current is limited to a maximum value of 1500 mA. The output voltage is programmed by an external resistor divider, or is fixed internally on the chip. The converter can be disabled to minimize battery drain. During shutdown, the load is completely disconnected from the battery. The device is packaged in a 10-pin VSON package measuring 3 mm × 3 mm.
| Tipo | Título | Fecha | ||
|---|---|---|---|---|
| * | Data sheet | TPS6120x Low Input Voltage Synchronous Boost Converter With 1.3-A Switches datasheet (Rev. E) | PDF | HTML | 24 dic 2014 |
| Application note | QFN and SON PCB Attachment (Rev. C) | PDF | HTML | 06 dic 2023 | |
| Application note | Basic Calculation of a Boost Converter's Power Stage (Rev. D) | PDF | HTML | 28 oct 2022 | |
| Application note | Performing Accurate PFM Mode Efficiency Measurements (Rev. A) | 11 dic 2018 | ||
| Selection guide | Power Management Guide 2018 (Rev. R) | 25 jun 2018 | ||
| Application note | Optimizing Transient Response of Internally Compensated DC-DC Converters (Rev. B) | 29 nov 2017 | ||
| Application note | Extending the Soft Start Time Without a Soft Start Pin (Rev. B) | 15 jun 2017 | ||
| Application note | Five Steps to a Good PCB Layout of the Boost Converter | PDF | HTML | 03 may 2016 | |
| Analog Design Journal | IQ: What it is, what it isn’t, and how to use it | 17 jun 2011 | ||
| Application note | Minimizing Ringing at the Switch Node of a Boost Converter | 15 sep 2006 |
Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.
The TPS61201EVM-179 is an evaluation module for the TPS61201 low input voltage synchronous boost converter. The TPS61200 provides a power supply solution for products powered by either a single-cell, two-cell, or three-cell alkaline, NiCd or NiMH, or one-cell Li-Ion or Li-polymer battery.
| Encapsulado | Pines | Símbolos CAD, huellas y modelos 3D |
|---|---|---|
| VSON (DRC) | 10 | Ultra Librarian |
El contenido lo proporcionan “tal como está” TI y los colaboradores de la comunidad y no constituye especificaciones de TI. Consulte los términos de uso.
Si tiene preguntas sobre la calidad, el paquete o el pedido de productos de TI, consulte el soporte de TI.