計算工具
TPS63036
- Input voltage range: 1.8 V to 5.5 V
(>2 V for device start-up) - Adjustable output voltage range: 1.2 V to 5.5 V
- High efficiency over the entire load range
- Operating quiescent current: 25 µA
- Power save mode with seamless transition
- Average current mode buck-boost architecture
- Automatic transition between modes
- Fixed frequency operation at 2.4 MHz
- Synchronization to external clock possible
- Safety and robust operation features
- Overtemperature, overvoltage protection
- Load disconnect during shutdown
- Tiny 8-pin wafer chip scale package (WCSP): 1.814 mm × 1.076 mm
The TPS63036 is a non-inverting buck-boost converter able to provide a regulated output voltage from an input supply that can be higher or lower than the output voltage. The buck-boost converter is based on a fixed frequency, pulse width modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters power save mode to maintain high efficiency over a wide load current range. The power save mode can be disabled, forcing the converter to operate at a fixed switching frequency.
The maximum average current in the switches is limited to a typical value of 1000 mA. The output voltage is programmable using an external resistor divider.
The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the supply.
技術文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 17 設計與開發
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
開發板
TPS63036EVM-163 — 單電感器降壓升壓轉換器評估模組
An evaluation module for Texas Instruments TPS63036, a highly efficient, single-inductor, buck-boost converter, in an 8-ball, 1.854-mm × 1.076-mm wafer chip-scale package (YFG). Capable of programming enable/disable, power save mode (PWM/PFM) and adjustable output voltage.
使用指南: PDF
模擬型號
TPS63036 Unencrypted PSpice Transient Model Package (Rev. A)
SLVM663A.ZIP (55 KB) - PSpice Model
參考設計
TIDA-01580 — 適用於醫療和消費者穿戴式裝置的無線 ECG、SpO2、PTT 和心率監測器參考設計
This reference design is a simple, wearable, multi-parameter, patient monitor that uses a single-chip, biosensing front end, AFE4900, for synchronized electrocardiography (ECG) and photoplethysmography (PPG) measurements. The measured data is transferred to a remote location using CC2640R2F (...)
參考設計
TIDA-010029 — 具備 Bluetooth® 5 的穿戴式 16 相位多感測器 SpO2 與心率監測器 (HRM) 參考設計
This reference design enables a wearable, optimized saturation of peripheral capillary oxygen (SpO2) and multi-sensor, multi-wavelength optical heart rate monitor (HRM). It uses AFE4420 device, which is a single-chip, bio-sensing front end for photoplethysmography (PPG) measurements. It supports up (...)
參考設計
TIDA-00554 — 具有 Bluetooth 連線且適用於可攜式化學分析的 DLP 超行動 NIR 光譜儀
The ultra-mobile near-infrared (NIR) spectrometer reference design utilizes Texas Instruments' DLP technology in conjunction with a single-element InGaAs detector to deliver high performance measurements in a portable form factor that is more affordable than architectures using an expensive InGaAs (...)
參考設計
TIDA-00079 — 1 級 PoE - 高效率 IP 攝影機電源模組參考設計
This IP Camera power module is a highly efficient power solution that enables high performance 1080p operation at the Class 1 PoE power level. This innovative power module, used in the low power DM385-AR331 IP Camera, relies on highly efficient switchers like the TPS5432 that are also very cost (...)
| 封裝 | 針腳 | CAD 符號、佔位空間與 3D 模型 |
|---|---|---|
| DSBGA (YFG) | 8 | Ultra Librarian |
訂購與品質
內含資訊：
- RoHS
- REACH
- 產品標記
- 鉛塗層/球物料
- MSL 等級/回焊峰值
- MTBF/FIT 估算值
- 材料內容
- 認證摘要
- 進行中持續性的可靠性監測
內含資訊：
- 晶圓廠位置
- 組裝地點