TPS40400

現行

具 PMBus™ 的 3-V 至 20-V、30-A 同步降壓控制器,包含遙測

產品詳細資料

Vin (min) (V) 3 Vin (max) (V) 20 Iout (max) (A) 30 Operating temperature range (°C) -40 to 125 Control mode Voltage mode Topology Buck Rating Catalog Vout (min) (V) 0.6 Vout (max) (V) 5 Features Dynamic Voltage Scaling, Enable, Frequency synchronization, PMBus, Power good, Pre-Bias Start-Up, Remote Sense, Synchronous Rectification, Tracking Iq (typ) (µA) 6000 Duty cycle (max) (%) 90 Number of phases 1
Vin (min) (V) 3 Vin (max) (V) 20 Iout (max) (A) 30 Operating temperature range (°C) -40 to 125 Control mode Voltage mode Topology Buck Rating Catalog Vout (min) (V) 0.6 Vout (max) (V) 5 Features Dynamic Voltage Scaling, Enable, Frequency synchronization, PMBus, Power good, Pre-Bias Start-Up, Remote Sense, Synchronous Rectification, Tracking Iq (typ) (µA) 6000 Duty cycle (max) (%) 90 Number of phases 1
VQFN (RHL) 24 19.25 mm² 5.5 x 3.5
  • Input Operating Voltage Range: 3 V to 20 V
  • PMBus Enabled Analog Controller
  • Reference 600 mV ± 1%
  • Remote Voltage Sense Amplifier
  • Internal 6-V Regulator and 6-V Gate Drive
  • Programmable Overcurrent Protection
  • Inductor Resistance or Series Resistance Used for Current Sensing
  • Programmable Switching Frequency: 200 kHz to 2 MHz
  • Powergood Indicator
  • Thermal Shutdown
  • Programmable Soft-Start
  • Internal Bootstrap Diode
  • Prebias Output Safe
  • 24-Pin QFN Package
  • Input Operating Voltage Range: 3 V to 20 V
  • PMBus Enabled Analog Controller
  • Reference 600 mV ± 1%
  • Remote Voltage Sense Amplifier
  • Internal 6-V Regulator and 6-V Gate Drive
  • Programmable Overcurrent Protection
  • Inductor Resistance or Series Resistance Used for Current Sensing
  • Programmable Switching Frequency: 200 kHz to 2 MHz
  • Powergood Indicator
  • Thermal Shutdown
  • Programmable Soft-Start
  • Internal Bootstrap Diode
  • Prebias Output Safe
  • 24-Pin QFN Package

The TPS40400 is a cost-optimized flexible synchronous buck controller that operates from a nominal 3-V to 20-V supply. This controller is an analog PWM controller that allows programming and monitoring through the PMBus™ interface. Flexible features found on this device include programmable soft-start time, programmable short circuit limit, and programmable undervoltage lockout (UVLO).

An adaptive anti-cross conduction scheme is used to prevent shoot through current in the power FETs. Gate drive voltage is 6 V to better enhance the power FETs for reduced losses. Short circuit detection occurs by sensing the voltage drop across the inductor or across a resistor placed in series with the inductor. A PMBus programmable threshold is compared to this voltage and is used to detect overcurrent. When the overcurrent threshold is reached, a pulse by pulse current limit scheme is used to limit the current to acceptable levels. If the overcurrent condition persists for more than 7 clock cycles of the converter, a fault condition is declared and the converter shuts down and goes into either a hiccup restart mode or latches off. The behavior can be selected through the PMBus interface. Other PMBus interface features include programmable operating frequency, soft-start time, overvoltage and undervoltage thresholds and the response to those events, output voltage change including margining as well as status monitoring.

The TPS40400 is a cost-optimized flexible synchronous buck controller that operates from a nominal 3-V to 20-V supply. This controller is an analog PWM controller that allows programming and monitoring through the PMBus™ interface. Flexible features found on this device include programmable soft-start time, programmable short circuit limit, and programmable undervoltage lockout (UVLO).

An adaptive anti-cross conduction scheme is used to prevent shoot through current in the power FETs. Gate drive voltage is 6 V to better enhance the power FETs for reduced losses. Short circuit detection occurs by sensing the voltage drop across the inductor or across a resistor placed in series with the inductor. A PMBus programmable threshold is compared to this voltage and is used to detect overcurrent. When the overcurrent threshold is reached, a pulse by pulse current limit scheme is used to limit the current to acceptable levels. If the overcurrent condition persists for more than 7 clock cycles of the converter, a fault condition is declared and the converter shuts down and goes into either a hiccup restart mode or latches off. The behavior can be selected through the PMBus interface. Other PMBus interface features include programmable operating frequency, soft-start time, overvoltage and undervoltage thresholds and the response to those events, output voltage change including margining as well as status monitoring.

下載 觀看有字幕稿的影片 影片

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 9
類型 標題 日期
* Data sheet TPS40400 3-V to 20-V PMBus Synchronous Buck Controller datasheet (Rev. D) PDF | HTML 2016年 11月 7日
User guide TPS40400 Buck Controller Evaluation Module User's Guide (Rev. A) PDF | HTML 2022年 1月 3日
Analog Design Journal Maximizing power density and thermal performance in power-module designs 2018年 12月 12日
Selection guide Power Management Guide 2018 (Rev. R) 2018年 6月 25日
Selection guide DC/DC Buck Controller Solutions Selection Guide 2018年 2月 6日
Application note SMT Guidelines for Stacked Inductor (Inductor On Top) on Voltage Regulator IC 2016年 2月 22日
Technical article Select the correct PMBus POL solution for your application PDF | HTML 2015年 8月 3日
Analog Design Journal 2Q 2012 Issue Analog Applications Journal 2012年 4月 26日
Analog Design Journal Remote sensing for power supplies 2012年 4月 26日

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

TPS40400EVM-351 — 用於 TPS40400 PMBus 同步降壓控制器的評估模組

The TPS40400EVM-351 evaluation module (EVM) is a fully assembled and tested circuit for evaluating the TPS40400 PMBus Synchronous Buck Controller in a typical single output application. The EVM is designed to use a regulated 8Vdc to 14Vdc bus to produce a regulated output of 1.2Vdc at a maximum of (...)

使用指南: PDF | HTML
TI.com 無法提供
應用軟體及架構

FUSION_DIGITAL_POWER_DESIGNER — 數位電源軟體

Fusion Digital Power™ graphical user interface (GUI) software is used to configure and monitor select Texas Instruments digital power controllers and sequencer/health monitors. The application uses the PMBus protocol to communicate with the device over serial bus by way of a TI USB adapter.
驅動程式或資料庫

PMBUSSW-LINUX — 適用於 PMBUS 的 Linux 驅動程式

The Linux driver supports PMBus controlled Buck Controllers. The Linux driver supports communication through the PMBus and interfaces with the HWMon framework.

 

Linux Mainline Status

Available in Linux Main line: Yes
Available through git.ti.com: N/A

Supported Devices:

  • tps40400
  • tps40422
  • tps544b20
  • tps544b25
  • (...)
模擬型號

TPS40400 IBIS MODEL

SLVMAY8.ZIP (81 KB) - IBIS Model
模擬型號

TPS40400 Unencrypted PSpice Transient Model Package (Rev. A)

SLUM560A.ZIP (221 KB) - PSpice Model
計算工具

SLUC263 Type III Compensation Calculation Tool

支援產品和硬體

支援產品和硬體

產品
AC/DC 和 DC/DC 控制器 (外部 FET)
TPS40007 源極/汲極、預偏壓運作的 2.25V-5.5V、300 kHz、同步降壓控制器 TPS40009 源極/汲極、預偏壓運作的 2.25V-5.5V、600 kHz、同步降壓控制器 TPS40021 增強的低輸入 (2.25V-5.5V) 高達 1MHz 頻率,同步降壓控制器,來源/接收器 TPS40040 具低接腳數的 2.25V 至 5.5V 輸入、300 kHz 同步降壓控制器 TPS40041 具低接腳計數的 2.25 至 5.5 V 輸入、600 kHz 同步降壓控制器 TPS40055 用作源極/汲極的寬輸入 (8V-40V) 最高頻率 1MHz 的同步降壓控制器 TPS40057 寬輸入 (8V-40V)、頻率高達 1MHz 的同步降壓控制器,帶有預偏置的輸出驅動/吸入 TPS40075 具電壓前饋的 4.5-V 至 28-V 同步降壓控制器 TPS40077 採用 HTSSOP 封裝,具有前饋電壓的 4.5-V 至 28-V 同步降壓控制器 TPS40101 具進階定序和輸出裕度的 4.5-V 至 18-V 同步降壓控制器 TPS40170 4.5 V 至 60 V 大範圍輸入同步 PWM 降壓控制器 TPS40190 4.5-V 至 15-V,20-A 同步降壓控制器 TPS40192 具電源良好的 4.5-V 至 18-V,20-A、600-kHz 同步降壓控制器 TPS40193 具電源良好的 4.5-V 至 18-V,20-A、300-kHz 同步降壓控制器 TPS40195 具電源良好輸出和同步功能的 4.5-V 至 20-V,20-A 同步降壓控制器 TPS40200 寬輸入非同步降壓 DC/DC 控制器 TPS40303 具 FSS 的 3-V 至 20-V,25-A、300-kHz 同步降壓控制器 TPS40304 具 FSS 的 3-V 至 20-V,25-A、600-kHz 同步降壓控制器 TPS40305 具 FSS 的 3-V 至 20-V,25-A、1.2-MHz 同步降壓控制器 TPS40322 雙輸出或二相同步降壓控制器 TPS40400 具 PMBus™ 的 3-V 至 20-V、30-A 同步降壓控制器,包含遙測 TPS40422 附 PMBus 的雙輸出或多相同步降壓控制器 TPS5130 具有 LDO 控制器的 4.5-V 至 28-V、三重同步降壓控制器
AC/DC 和 DC/DC 轉換器 (整合式 FET)
TPS53311 具 Eco-Mode 和流暢 PWM 的 2.9V 至 6V 輸入、3A 同步降壓轉換器 TPS53313 具最佳化輕負載效率的 4.5-V 至 16-V、6-A 同步降壓轉換器 TPS53316 具整合切換器的高效,5A降壓調節器 TPS56121 4.5-V 至 14-V、15-A 同步 SWIFT™ 降壓轉換器 TPS56221 4.5-V 至 14-V、25-A 同步 SWIFT™ 降壓轉換器
參考設計

PMP21440 — 比較:0.8V/8W GaN 與矽片電源供應參考設計

This reference design provides customers with a comparison study on the usage of GaN vs SI in power supply designs. This specific design uses TPS40400 controller to drive CSD87381 for the silicon power supply and LMG1210 with EPC2111 for the GaN power supply to provide 0.8V/10A. This design (...)
Test report: PDF
電路圖: PDF
封裝 針腳 CAD 符號、佔位空間與 3D 模型
VQFN (RHL) 24 Ultra Librarian

訂購與品質

內含資訊:
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊:
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片