TPS40170
- New, similar products available:
- Wide input voltage range from 4.5 V to 60 V
- Reference voltage of 600 mV with 1% accuracy
- Programmable UVLO and hysteresis
- Voltage mode control with voltage feed forward
- Programmable frequency between 100 kHz and 600 kHz
- Bi-directional -frequency synchronization with primary and secondary option
- Low-side FET sensing overcurrent protection and high-side FET sensing short-circuit protection with integrated thermal compensation
- Programmable closed loop soft-start
- Supports pre-biased outputs
- Thermal shutdown at 165°C with hysteresis
- Voltage tracking
- Power good
- ENABLE with 1-µA low current shutdown
- LDO output of 8.0 V and 3.3 V
- Integrated Bootstrap Diode
- 20-Pin 3.5 mm × 4.5 mm VQFN (RGY) package
- Create a Custom Design with WEBENCH Tools
TPS40170 is a full-featured, synchronous PWM buck controller that operates at an input voltage between 4.5 V and 60 V and is optimized for high-power density, high-reliability DC-DC converter applications. The controller implements voltage-mode control with input voltage feed-forward compensation that enables instant response to input voltage change. The switching frequency is programmable from 100 kHz to 600 kHz.
The TPS40170 has a complete set of system protection and monitoring features such as programmable undervoltage lockout (UVLO), programmable overcurrent protection (OCP) by sensing the low-side FET, selectable short-circuit protection (SCP) by sensing the high-side FET and thermal shutdown. The ENABLE pin allows for system shutdown in a low-current (1 µA typical) mode. The controller supports pre-biased output, provides an open-drain PGOOD signal, and has closed-loop soft-start, output voltage tracking and adaptive dead-time control.
TPS40170 provides accurate output voltage regulation through 1% ensured accuracy. Additionally, the controller implements a novel scheme of bi-directional synchronization with one controller acting as the primary and other downstream controllers acting as secondaries synchronized to the primary in-phase or 180° out-of-phase. Secondary controllers can be synchronized to an external clock within ±30% of the free-running switching frequency.
New products (LM5145 and LM5146) offer reduced BOM cost, higher efficiency, and reduced design size among many other features.
技術文件
設計與開發
如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。
AUTOCRANKSIM-EVM — 適用於汽車啓動脈衝的模擬器評估模組
The Cranking simulator generates preprogrammed cranking pulses, resembling typical pulse as seen on Car-Battery during cranking (e.g. during start-stop operation). Other pulses can be configured via source-code change, which makes it applicable for any supply-voltage profile in the range of 2.18V.
(...)
TPS40170EVM-578 — 用於 TPS40170 同步 PWM 降壓控制器的評估模組
TPS40170EVM-597 — 具有 NexFET™ 的 TPS40170 同步 PWM 降壓控制器評估模組
The TPS40170EVM-597 is a fully assembled and tested circuit for evaluating the TPS40170 synchronous step-down controller with two NexFET devices CSD18537NQ5A and CSD18563Q5A. The TPS40170EVM-597 operates from a 10V to 36V input (24V nominal) and provides a 5V output up to 10A.
PMP15025 — 適用於工業機器人和馬達驅動器的 24V 轉 5V@4A 輸出參考設計
PMP10799 — 24V 輸入轉 12V@8A 同步降壓轉換器參考設計
PMP9668 — 通用 uP 控制電池充電器 24Vin、最大 10 Aout、5/12V 2A 和 5V 4A、2 個 USB 連接埠參考設計
PMP11494 — 48V 輸入轉 24V@12A (15A 峰值電流) 同步降壓轉換器參考設計
封裝 | 針腳 | CAD 符號、佔位空間與 3D 模型 |
---|---|---|
VQFN (RGY) | 20 | Ultra Librarian |
訂購與品質
- RoHS
- REACH
- 產品標記
- 鉛塗層/球物料
- MSL 等級/回焊峰值
- MTBF/FIT 估算值
- 材料內容
- 認證摘要
- 進行中持續性的可靠性監測
- 晶圓廠位置
- 組裝地點