ANALOG-ENGINEER-CALC — PC software analog engineer's calculator
Supported products & hardware
Products
Analog current-sense amplifiers
Analog current-sense amplifiers with integrated shunt resistor
Audio line receivers
Audio op amps
Biosensing AFEs
Die & wafer services
Difference amplifiers
Digital power monitors
Digital power monitors with integrated shunt resistor
Fully differential amplifiers
General-purpose op amps
High-speed ADCs (≥10 MSPS)
High-speed op amps (GBW ≥ 50 MHz)
Instrumentation amplifiers
Line drivers
Power op amps
Precision ADCs
Precision op amps (Vos<1mV)
RF receivers
RF transmitters
Touchscreen controllers
Transconductance amplifiers & laser drivers
Transimpedance amplifiers
Video amplifiers
ANALOG-ENGINEER-CALC — PC software analog engineer's calculator
Analog Engineer's Calc Installer
Products
Analog current-sense amplifiers
Analog current-sense amplifiers with integrated shunt resistor
Audio line receivers
Audio op amps
Biosensing AFEs
Die & wafer services
Difference amplifiers
Digital power monitors
Digital power monitors with integrated shunt resistor
Fully differential amplifiers
General-purpose op amps
High-speed ADCs (≥10 MSPS)
High-speed op amps (GBW ≥ 50 MHz)
Instrumentation amplifiers
Line drivers
Power op amps
Precision ADCs
Precision op amps (Vos<1mV)
RF receivers
RF transmitters
Touchscreen controllers
Transconductance amplifiers & laser drivers
Transimpedance amplifiers
Video amplifiers
Release Information
General calculator tool for analog design support.
What's new
- Added Stability > Cap. on Inverting node and Stability > Riso-Dual-Feedback tool. These tools determine phase margin for common op amp topologies.
- Changed Amplifier and Comparators > INA Vcm vs Vout for INA321 and INA322. These are both 2 amp + gain topologies. The change corrected an issue with output swing to the positive rail when gain is greater than 5V/V.
- Changed start up version test to check for the new version after all the files are updated. Previously, this was checked on startup and for new installs the “a new version is available” message would pop up.
- Changed version and date to be a global. These globals are displayed in the “about” pop-up (accessible in the links tab).
- Added the “What Changed?” feature.